LPI

ROVER VARIABLE LNB POWERING INSERTER
Indipendent voltage selections 13/18 V & 22 KHz tone for up to 10 LNBs

ROVER LPI-10
  • 50 – 3.000 MHz ultra wide band operating Frequency Range
  • Up to 10 LNBS with indipendent voltage selection 13 / 18 V, 22 KHz tone
  • Up to 500 mA current consumption per each LNB, with indipendent C.C.Protections & Alarms
  • Hot-swap dual redundant Power Supplies with separate Mains and related LEDS & Dry Contacts Alarms

ROVER LPI-10-V-F EN v4 front panle

ROVER LPI-10-V-F EN v4 rear panel

RF SPECIFICATIONS:

  • FREQ. RANGE = 50-3.000 MHz
  • CONNECTORS = F (or BNC or SMA)
  • IMPEDANCE = 75 Ohm (50 Ohm opt.)
  • RETURN LOSS = > 16 dB
  • INSERTION LOSS = 0,5 dB typ (1,5 max)
  • MAX. POWER INPUT = + 30 dBm
  • FLATNESS OVER THE ENTIRE BAND = <1,5 dB
  • FLATNESS IN 36 MHz WINDOW = < 0,5 dB
  • ISOLATION BETWEEN ADJACENT PATHS = > 60 dB

LNB POWER CONTROL:

  • D.C. VOLTAGE = OFF, 13V, 18V (or 24 optional) max 500 mA for each LNB, max 5A total
  • TONE = 22 KHz ON/OFF
  • LED green = OK, red = dc short circuit Alarm
  • LED ALARM INDICATION Via dry contact

DRY CONTACT ALARM:

  • CONNECTOR = SUB-D9 Male
  • CONTACT LOAD = 65 V – 400 mA
  • A & B MAINS PSU = one defective or both
  • LNB = dc Short Circuit

REDUNDANT POWER SUPPLY:

  • N. 2 AC MAINS PSU = 110-240 VAC (with 2 separate receptacle for 2 separate Power LINE)
  • AC POWER CONSUMPTION = < 25 VA

GENERAL SPECIFICATIONS:

  • SLIM CASE = 19” 1U Rack (32 cm deep)
  • NET WEIGHT = 3 Kg
  • SAFETY = EN 50 083-1 and EN 60 950.
  • ENVIRONMENT:
    – Temperature range: –30° / + 55° (max 70°)
    – Umidity 95%
  • EMC = EN 50 083-2

ROVER LPI-10-V-F EN v4 ordering code

Download